MIL-DTL-5882E
MIL-STD-130
-
Identification Marking of U.S. Military Property
MIL-STD-810
-
Environmental Test Methods & Engineering Guidelines
MS28005
-
Transmitter, Pressure-Synchro, Aircraft
MS28010
-
Indicators, Pressure Synchro, Single, 2 Inch Size
DEPARTMENT OF DEFENSE HANDBOOKS
MIL-HDBK-781
-
Reliability Testing For Engineering Development,
Qualification & Production
(Copies of these documents are available online at https://quicksearch.dla.mil/ or from the
Standardization Documents Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA
19111-5094.)
2.2 Order of precedence. In the event of a conflict between the text of this document and
the references cited herein, the text of this document takes precedence. Nothing in this document,
however, supersedes applicable laws and regulations unless a specific exemption has been
obtained.
3. REQUIREMENTS
3.1. Qualification. The transmitter furnished under this specification shall be products
that are manufactured by a manufacturer authorized by the qualifying activity for listing on the
applicable qualified products list (QPL) before contract award (See 4.1 and 6.3).
3.2 General requirements. The requirements of MlL-PRF-5350 are applicable as
requirements of this specification. Additional requirements shall be as specified herein. Where
the requirements of the general specification and this specification conflict, the requirements of
this specification shall govern.
3.2.2 Reclaimed materials. Reclaimed materials shall be utilized to the maximum extent
possible within the quality limits required by this document.
3.3. Design and construction.
3.3.1 General Design. The transmitters shall be designed for use with an MS28010-1
indicator conforming to MIL-I-7085.
3.3.2 Hermetically sealed case. The case shall provide a hermetically sealed enclosure
for the entire internal mechanism of the transmitter. The design of the case shall permit removal
and replacement of the internal mechanism and resealing of the case. This shall be accomplished
without the use of special tools and fixtures unless they are approved by the contracting activity.
The hermetic sealing shall be so accomplished that the seal will not be dependent upon materials
which will be affected by the action of any environment to which the transmitter may be
subjected.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business